![]() ![]() Retry your cuts with a new blade housing.If the firmware is not up to date, perform a Firmware Update using Cricut Craft Room, a Gypsy device, or Cricut Design Studio. Check your machine's firmware version.If this does not change the cut result, proceed to 6. Increase blade depth by turning the dial at the top of the blade housing.If this does not change the cut result, proceed to 5. Increase the machine pressure settings and try your cuts again.If they bounce right back up when released, proceed to 4. Do they bounce right back up, or do they stick or rub in any way? If they stick or rub, please contact Customer Care through one of the options below for further assistance. Try an arm buoyancy test: gently press down on the black arms that surround the blade housing and then release them. ![]() If the blade and housing are already free from debris, or cleaning it did not help, proceed to 3. ![]() Ensure that you replace the blade housing correctly into the machine.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |